×
Description
4201 708 3014 STIHL Thrust Washer Ø103 mm – Genuine OEM Part
The STIHL Thrust Washer Ø 103 mm (4201 708 3014) is a genuine OEM replacement thrust washer designed for use in the guard and support assemblies of select STIHL cut-off machines.
This thrust washer is a critical internal support component used to reduce friction, distribute axial load, and maintain proper alignment of rotating or supported components within the guard and connector assemblies. Proper thrust washer condition is essential for smooth operation, reduced wear, and long service life of cutting system components.
Manufactured to STIHL factory specifications, this OEM thrust washer ensures correct diameter, fitment, and durability under demanding professional cutting conditions.
Replacing a worn or damaged thrust washer helps restore proper component spacing and prevents premature wear or failure of surrounding parts.
Product Details
-
OEM Part Number: 4201 708 3014
-
Brand: STIHL (Genuine OEM)
-
Part Type: Thrust Washer
-
Diameter: Ø 103 mm
-
Application: Guard / support assembly internal component (model-specific)
-
Condition: New Genuine OEM Part
Function
This OEM thrust washer is designed to:
-
Reduce friction between supported components
-
Distribute axial load within the cutting guard assembly
-
Maintain correct spacing and alignment
-
Replace worn or damaged thrust washers
-
Help prevent premature wear of guards, connectors, and rotating parts
⚠️ A worn thrust washer may cause misalignment, noise, or accelerated component wear.
Verify Fitment (Recommended)
Before ordering, confirm:
-
OEM part number 4201 708 3014
-
Washer diameter Ø 103 mm matches your application
-
Application matches your STIHL illustrated parts diagram
⚠️ Thrust washers vary by model and guard configuration — always verify fitment by OEM part number.
Compatibility
Fits select STIHL models and configurations, including:
-
TS 350 / TS 350 AVE (Support with guard)
-
TS 360 (Support with guard)
-
TS 400 (Support with guard)
-
TS 410 / TS 410-A (Connector, Guard)
-
TS 420 / TS 420-A (Connector, Guard)
-
TS 440-A (Deflector)
-
TS 460 (Support with guard)
-
TS 480i-A (Connector, Guard)
-
TS 500i-A (Connector, Guard)
-
TS 510 (Support with guard – 38.1995)
-
TS 700 (Support with guard with water attachment – 43.2007)
-
TS 710.0i (Support with guard)
-
TS 760 (Support with guard – 38.1995)
-
TS 800 (Support with guard with water attachment – 14.2014)
-
TS 910.0i (Support with guard)
-
TSA 350.0 (Cast arm with guard)
-
TSA 500.0-B (Cast arm with guard)
(Exact application depends on configuration — verify using OEM parts diagram.)
Installation Notes
-
Disassemble guard/support components as required
-
Remove worn or damaged thrust washer
-
Install thrust washer 4201 708 3014 in correct position
-
Ensure proper seating and alignment
-
Reassemble securely following STIHL service procedures
⚠️ Internal service should be performed by a qualified technician.
Maintenance Tips
-
Inspect thrust washers during routine guard or driveline service
-
Replace washers showing wear, scoring, or deformation
-
Keep components clean and properly assembled
-
Always use genuine STIHL OEM washers for correct fit and durability
